CUSTOMISE FUNCTION


Using M.U.T.-III and SWS monitor adjusts the following function. The programmed information is held even when the battery is disconnected.
Item No.
Items shown on M.U.T.-III screen
Item
Adjustment item shown on M.U.T.-III screen
Adjusting content
2
Headlamp auto-cut
Headlamp automatic-shutdown function
Spec.B(EU/EXP)
With function: The automatic tail lamp turn-off function with the ignition switch OFF (LOCK) is not available. (Initial setting)
Without function
Without function
4
Wiper speed-sensitive operation
Vehicle speed-dependent wiper function
With function
With function (Initial setting)
Without function
Without function
15
Turn-signal buzzer
Turn-signal lamp buzzer function
With function
With function
Without function
Without function (initial setting)
16
Room lamp delay timer
Dimmer interior lamp control duration
30sec.
30 seconds
15sec.
15 seconds (initial setting)
7.5sec.
7.5 seconds
Without function
0 second (no delay action)
24
Timer relock after unlocking
Timer lock time after executing the keyless entry unlock
30sec.
30 seconds (initial setting)
60sec.
1 minute
120sec.
2 minutes
180sec.
3 minutes
26
Door ajar buzzer
Door-ajar warning function
With function
With function (Initial setting)
Without function
Without function
Sequential ope.
Continuous operation
28
Rear wiper intermittent time
Rear wiper intermittent duration
8sec.
8 seconds: Without continuous operation (Initial setting)
4s(Sequential*)
4 seconds: With continuous operation
8s(Sequential*)
8 seconds: With continuous operation
16s(Sequential*)
16 seconds: With continuous operation
Sequential* ope.
Continuous operation (without the intermittence)
4sec.
4 seconds: Without continuous operation
16sec.
16 seconds: Without continuous operation
30
Room lamp auto-cut
Operation duration of interior lamp automatic-shutoff function
3min.
3 minutes
30min.
30 minutes (initial setting)
60min.
60 minutes
Without function
Without function
31
P/W lock-mode operation
Power window lock operation on the driver’s seat <Vehicles for South Africa>
All SW operable
Driver can operate power windows on all doors even when the power window lock is ON (Initial setting).
Only main SW
Operating seats other than the driver’s seat is prohibited when lock is ON.
37
Wiper synchronized washer
Wiper linked with washer function
With function
With function (Initial setting)
Without function
Without function
39
Turn-signal operation
Turn signal lamp operation condition adjustment function
When IG ON
Turn signal lamp can be operated when the ignition switch is turned ON (Initial setting).
When IG ACC
Turn signal lamp can be operated when the ignition switch is in ACC or ON position.
40
Hazard answer-back operation
Keyless entry hazard answer-back flashing pattern adjustment function
LOCK:1/UNLOCK:2
LOCK: Flash once, UNLOCK: Flash twice (Initial setting)
LOCK:1/UNLOCK:0
LOCK: Flash once, UNLOCK: No flash
LOCK:0/UNLOCK:2
LOCK: No flash, UNLOCK: Flash twice
LOCK:2/UNLOCK:1
LOCK: Flash twice, UNLOCK: Flash once
LOCK:2/UNLOCK:0
LOCK: Flash twice, UNLOCK: No flash
LOCK:0/UNLOCK:1
LOCK: No flash, UNLOCK: Flash once
Without function
No flashing
60
Reception of comfort flasher
Switch operation time to activate the comfort flasher function
400 msec
0.4 seconds (Initial setting)
800 msec
0.8 seconds
Without function
Without comfort flasher function
note
  • *: The wiper operates consecutively when the rear wiper switch is operated twice in less than one second.
  • Adjustment items other than the above will also be shown on M.U.T.-III screen. However, they cannot be reconfigured.