CRUISE CONTROL SYSTEM COMPONENT CHECK



CRUISE CONTROL SWITCH CHECK


1.Remove the cruise control switch (Refer to ).

2.Measure the resistance between terminal No.2 and terminal No.3 when each of the "ON/OFF", "CANCEL", "COAST/SET" and "ACC/RES" switches is pressed. If the values measured at the time each switch is pressed correspond to those in the table below, the resistance values are correct.
Terminal connector of tester
Switch position
Specified condition
2 - 3
All switches are released.
Open circuit
"ON/OFF" switch is pressed
Continuity (less than 2Ω)
"CANCEL" switch is pressed
202.5 - 208Ω
"COAST/SET" switch is pressed
610.5 - 624.5 Ω
"ACC/RES" switch is pressed
1838 - 1877 Ω
3.Check that illumination of the cruise control switch turns on when the battery positive terminal is connected to cruise control switch connector terminal No.4, and the battery negative terminal is connected to cruise control switch connector terminal No.1.

STOP LAMP SWITCH CHECK


Refer to GROUP 35A - Brake Pedal, Inspection, Stop Lamp Switch Check .

CLUTCH SWITCH CHECK


Refer to GROUP 21A - On-vehicle Service, Clutch Switch Check .